Latest Products
-
Planes
X-UAV Mini Talon EPO 1300mm Wingspan V-tail FPV Plane Aircraft Kit
The Mini Talon V-tail plane is the smaller version of the popular Talon Kit. The kit comes un-assembled with EPO and laser cut plywood parts.Runs 4S 14.8V 10,000mAh LIPO battery, flight times are long, and wing loading still low thanks to the generous wing area of the Talon. A generous fuselage compartment with large top hatch allows you to access your equipment and flight battery in any configuration you choose. It is a great plane for anything you want to throw at it.you can use these for site surveying, aerial mapping and FPV fun.
SKU: n/a -
Flight Controller, GPS
Radiolink Pixhawk + SE100 GPS Combo
The Pixhawk flight controller released by Radiolink comes with less interference of inner components, unique automation software testing system. Optimize the PCB layout, improve the Baro and Altitude Hold. For the GPS module, it has 50 centimeters position accuracy, positionning 20 satellites in 6 seconds at open ground.
SKU: n/a -
-
-
Foxeer, FPV
Foxeer Reaper Extreme 5.8G 2.5W 40CH VTx
The Foxeer Reaper Extreme 2.5W VTX is one of the highest power output VTX’s on the market that are still reasonably sized for our FPV quads. It is a great choice for the Long Range guys or for those who need high power VTX to fly in video power demanding locations.
SKU: n/a -
-
DJI, DJI & Accessories
DJI Avata (No RC)
- Immersive Flight Experience
- Intuitive Motion Control
- 4K/60fps 155° Super-Wide FOV Videos
- Powerful Video Stabilization
- Weighs About 410 g, Lightweight and Portable
- Enhanced Safety with Built-in Propeller Guard
- 10km 1080p Low-Latency Video Transmission DJI Avata
SKU: n/a -
Sensors
Pololu VL53L0X Time-of-Flight Distance Sensor Carrier with Voltage Regulator
This sensor is a carrier/breakout board for ST’s VL53L0X laser-ranging sensor, which measures the range to a target object up to 2 m away. The VL53L0X uses time-of-flight measurements of infrared pulses for ranging, allowing it to give accurate results independent of the target’s color and surface. Distance measurements can be read through a digital I²C interface. The board has a 2.8 V linear regulator and integrated level-shifters that allow it to work over an input voltage range of 2.6 V to 5.5 V, and the 0.1″ pin spacing makes it easy to use with standard solderless breadboards and 0.1″ perfboards.
SKU: n/a
